Home Blog Which Ball Bearing Fishing Swivels Do I Use

Which Ball Bearing Fishing Swivels Do I Use

Release time : 2015-06-11 07:41:43
By Bearing Manufacturer>Bearing News>Which ball bearing fishing swivels Do I Use? ?2004-2012 How big a ball bearing fishing swivels do I need? How much fishing weight do I use? Which swivel do I use? The answer may surprise you! Ball bearing fishing swivels are the part of your terminal tackle that does just what the name implies - they sink! They are designed to take your bait down into the water. Lots of anglers don't think much about their ball miniature bearing fishing swivels. They just put one on and hope for the best. But having the proper ball bearing fishing swivels in the proper weight can mean the difference between fish and no fish. Ball Bearing Fishing Swivels Material Ball bearing fishing swivels sealing surface and seals made ??of special materials, abrasion resistance, long life, corrosion-resistant, does not leak. The status of the internal seal wear may be the appearance of the product visually learned, can prevent mechanical downtime or mechanical damage, came to the preventive effect and reduce losses. Within the independent pipeline needs to make choices, to maximize the benefits for different work. The housing and the rotating shaft supported by precision High Speed Bearings, so that when the rotation of the rotary joint flexible and lightweight, the friction force is small, the liquid medium may include water, oil, air, etc., use of industry wide. The seals wear simple replacement repair, do not have to re-purchase of new, cost-saving. Fish Finder Rigs A fish finder rig is a good rig for catching fish that feed on or near the bottom in salt water and fresh water. This rig combines a swivel, lead, and hook to efficiently get your bait to the bottom and keep it in position without interfering with its action. For that reason, it works well with live bait as well as cut and prepared bait, and will work in still and flowing waters. Start by tying a heavy swivel to the end of your main line. To the other eye of the swivel tie on a lighter leader twelve to thirty-six inches long, depending on how high you want your bait off the bottom (a lighter leader is a piece of line that is lower-pound test than the main line). Attach a Bell sinker to the end of this leader. Then tie another leader to the same eye if you're using a single swivel, or to the third eye if your using a three-way swivel. Attach your hook to this leader and bait it up. The hook leader can be any length you need it to be to allow the bait to work freely. If you want it near the bottom, make is as long or longer than the sinker leader. If you want to keep it up off the bottom tie it shorter than the sinker leader. As the Needle Roller Bearings sits on the bottom or drags along, the bait will follow behind it slightly above it, depending on how long you made the hook leader. This rig is great for drift-fishing or still-fishing. And if you have problems with the sinker hanging up, the lighter leader should break and allow you to reel in your hook and bait or any fish that hit. You can also use an Egg sinker on the end and either peg it with a toothpick or crimp on a Split Shot below it, rather than tying it to the leader. That way it will slide off the line when hung rather than break the leader. You can quickly slip another sinker on the end and be fishing again. You can also add a float to a fish finder rig to help make it work better. When drifting over a flat bottom the float can keep the lead just bumping the bottom. If casting, use a slip bobber (a bobber with a hole through the center that allows the line to move freely) and you can detect bites. It will also help you reel in your rig because it pulls the hook and lead up to the surface and away from trash on the bottom that would hang it up.